Pull aff ac bracket and the wire will lead you there
where is the engine number on a 1997 daewoo nubira
It's located on the firewall up top just behind the engine.
According to the Gates website ( they make timing belts etc. ) the ( 2.0 liter engine ) in a 2002 Daewoo Nubira ( is an interference engine )
Back of the engine block. 3 bolts to release and ridiculously hard to reach.
i Have a nubira II premium M.2000 1.5Ltr and the Map Sensor is located just under the Wind screen wipers inside the engine compartment, to the left of the Coil
What is the cylinder head torque specs for a 2001 daewoo nubira 2.0 litre engine and what is the proper torque order
Have vehicle scanned to determine the problem
The water pumb is driven by the timing belt. When looking at the front of the car, the front of the engine is on the left. The water pump is located at the bottom left of the engine.
Remove the cowling on top of the engine block to expose the head, you should be able to see and follow the HT leads.
2.2L D-tech . Its a 16 valve, dual overhead cam engine, with 130hp.
The compressor is located on the lower part of the engine and is driven by one belt from the crankshaft to the idler and back to the compressor...........
Most Vauxhall bits will fit the 2.0 and are usually cheaper - Paula
The fuel filter is located at the rear of the engine bay, at the top near the firewall. Take care removing and a special tool may be required.
The throttle position sensor is mounted to the throttle body on the opposite side of the throttle cables and is faceing the rear of the engine compartment.
The crankshaft is the largest part in the bottom of the engine.The crankshaft is the largest part in the bottom of the engine.
needs put on a diagnostic scanner, that should put the light out
On the back of the engine block. 3 bolts to take it off, easy to do but hard to reach.
The crankshaft is located inside the lower half of the engine. The engine must be removed and disassembled to gain access to the crankshaft.
Really need more info (engine size, model, type, etc..) A 1.6L DOHC, should be located about 9'o-clock if looking at the Crankshaft pulley through the right side wheel well. Just FYI the camshaft sensor is located under the timing belt cover between the two camshafts (1.6L DOHC) but behind the exhaust cam gear (gear towards front of car).
Where is located the crankshaft sensor in Chevy avalanche 2002 engine 5.3?
check oil pressure with a gauge possible bad pump or engine is tired
Lowest pulley on engine