The sensor is located at the 12 o'clockposition on top of the bell housing and directly above the flywheel. It is in close quarters to the firewall and takes some patients to disconnect it from the harness and remove the two bolts securing it to the bell housing. A moderate task to accomplish, but it can be done from the top of the engine.
It on the back of the coil packs going into the side of the block.
Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing.
the crankshaft sensor is behind the cylinder head on the top of the bell-housing (where the motor and transmission bolt together)
Top of the transmission bell housing.
its bolted to the cylinder block near the rear of the right cylinder head
The flex plate is the flywheel. It is between the crankshaft and torque converter. The crankshaft position sensor is located behind the passenger side cylinder head, through the top of the transmission case.
Under the timing belt cover!
The crankshaft position sensor on a Dodge 5.9L V8 is located behind the passenger side cylinder head, and it aims at the flywheel through a hole in the bell housing.
It is located inside the timing cover on the right side of the crankgear
Where is a crankshaft sensor located on a nissan almera 2001
CID = cylinder identification sensor is the same as a Crankshaft Position Sensor. Look for it by the harmonic balancer
Four cylinder, center rear if the block. Six cylinder, top rear of the bell housing.