0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Location of crankshaft sensor in 1997 GM suburban?
It does not have a crank shaft sensor.
Crankshaft position sensor in 97 GM sonoma 2.2 engine?
The crankshaft position sensor on a 97 GM Sonoma 2.2 engine is located on the lower right side of the engine. It is near the ignition control module.
Where on 97 gm 350 vortec engine would you find the crankshaft position sensor?
the crankshaft position sensor is located at the underneath side of the engine right at the bottom of the timing chain cover / front of oil pan
Who made the engine in an Isuzu Rodeo?
If you mean the 3.2 litre V6,engine, no- 6VDI then it's Isuzu's Own engine and NOT a GM earlier type.
Where is the crankshaft position sensor on a 2000 5.3 lt gm?
It is behind the atarter in the side of the engine block. Must remove starter to get to it.
Where is the crankshaft position sensor located on 2007 GM ACADIA 3.6?
It should be in the front of the engine, just behind the vibration dampener.
You have no spark or fuel injection spray on a 1993 GMC 5.7L?
check the CKP sensor (crankshaft position sensor). It is usually used for injector triggering on 90's GM vehicles.
Where is the Gm 3800 series 3 crank position sensor located?
Undecided QuestionShow me another » Where is the camshaft position sensor located on a 1997 pontiac with a 3800 motor
How do you change the crankshaft position sensor on a 2001 Pontiac Grand Prix?
remove the front passenger wheel, remove the crank pulley, remove the crank sensor. you may need a GM special tool to remove certain bolts
Where is the crankshaft position sensor located on a 2003 GM 4.3 liter engine?
should be on the block about 2/3 way down on the pass. side, or on top of the trans on the drivers side
Where is oil pan on GM Yukon XL?
Right below the crankshaft.
1996 gm 3.8 crank sensor location?
Crankshaft sensor for the 96 olds 3.8 v/6 is behind the harmonic balancer mounted on a bracket. It is adjustable and must be set properly to avoid damage to the replacement. There is a clearance issue between the sensor and the blades attached to the back side of the harmonic balancer.
