Want this question answered?
is there a diagram or a picture of the distributor cap and rottor in a 95 ford probe gt 2.5lt
i am trying to bleed the clutch of air, i need to find the brake adjustment hole cover and open it before releasing the bleeder valve, BUT I CANNOT FIND THE BRAKE ADJUSTMENT HOLE COVER ON THE CLUTCH SLAVE CYLINDER, HELP?
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
What is your question?
hi! i had the same problem on my '94 SE and it was caused by the distributor.
Distributor Assembly Mounting
r134a
there are twoCrank sensors on the ford probe GT. One is located in the distributor that control spark and by taking the passenger front wheel off and to the right of the crank shaft pully you will see a one bolt device with three wires, that is your lower crank sensor.
Built into the distributor.
the pick up is inside the distributor
I have a 94 Probe GT. 2.5 V6. It has a belt, not a chain. Best bet is to get a Haynes manual ($17.00), theres a lot of goodies to remove. -CE
Yes. body parts, interior parts and most motor componets are interchangeable. However, the 94 Probe is an OBD-I and the 97 Probe is an OBD-II so there are additional sensors on the 97 Probe to consider if swapping motors/wire harnesses, etc.