there are two
Crank sensors on the Ford Probe GT. One is located in the distributor that control spark and by taking the passenger front wheel off and to the right of the crank shaft pully you will see a one bolt device with three wires, that is your lower crank sensor.
2.0ltr its in distributer
Where is the crank sensor located on a 94 ranger 4.0 motor
its Located next to the Crank pully just to the side of it on the lower passenger side of the motor bottom.
The dome light and floor lights on a 94 Ford Probe will not go off if the door is open or the door sensor has not been tripped. The lights can be manually turned off but the sensor should be checked for defects.
if the 94 probe is a GT, yes. the 2.0l alternators are different from the GT the autozone part numbers for the 94 2.0L Probe is 14449 and the part number for the 94 2.5L GT is 14450
r134a
Was not used in that year.
The crank angle sensor is located in the distributor.only in the 94 and 95 Honda accord.
Because it's a Ford.
The easiest and most effective way to check a crank sensor is with a diagnostic tester. The diagnostic tester can determine whether the crank sensor is working properly.
Your speed sensor on a 94 jeep jy is near the crank shaft. I hope i answered your question.
Nope 98-94 is one model. 95 starts a new design.