Want this question answered?
Where is the ecm on a 03 explorer
unfortunately, you cant. it is controlled bu the ecm. you must have either a vaccum leak or an egr problem. also could be the idle air control valve. good luck!!
Where is the ECM located on ford expidition 4.6
yes but the #s on top of your pcm must match your used 1.most big salvage yards sell them for $75.00 with a 30 day warrenty.
I have a 2002 Ford sport Trac I have a code of P0320. Do you know the part number to fix this? Seems when the engine warms up, during driving, the truck stalls & sputters & then quits when I brake or come to a full stop. It starts right up again, then stalls when shifted into drive. Had fuel module replaced & airflow cleaned. What else can it be? Was told by a handheld device, was P0320.
The 1997 Ford Ranger ECM computer is located behind the dashboard. The computer will be on the passenger side of the passenger compartment.
The 1993 Ford F1 50 ECM is located on the back of the transmission. The ECM will be near the bottom of the transmission.
You start by identifying the cause of the fault, e.g., is the sensor itself, a wiring issue, or an ECM issue? How you go about with the actual repair depends on what the result of your diagnosis is.
There is no fuse for the oxygen sensor. The only fuse is for the ECM. --------------------------------------------------------------------------------------------------------- On a 1997 Ford Explorer, there is a 20 amp mini fuse for the Hego system (heated exhaust gas oxygen sensor) in location # 11 in your power distribution box in the engine compartment. THE PD BOX IS LIVE - DISCONNECT YOUR BATTERY CABLES (Helpfull)
in the passenger kick panel
Need to reprogram the ECM.
no....