0
Above the rear axle, drivers side.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the evap canister on1998 s-10 pickup?
where is the evap canister on 1998 s-10 pick-up. It should be under the rear of the truck, behind drivers side rear tire..
Where is the evap canister located on a S-10 Chevrolet pickup?
On a 2002 Chevy S-10 4WD Crew Cab, it is mounted underneath the bed, drivers side, above the rear axle. It's a black rectangular canister, dealer priced at about $180.
You want to see a diagram of a evap canister on a 97 s10?
Your Chevy1997 S-10 came with an owners manual when you purchased it. If you look in it, you should find a diagram of an evap canister. This will help you navigate things easier.
Evap canister is leaking fuel on a s-10?
You can remove it and clean the filter inside it or you can replace it.
Where is the evap canister located in the 2000 Chevy S-10?
Above the drivers side rear axle, attached to the frame.
1997 Ford Taurus OBD code po443?
P0443 EVAP Canister Purge Solenoid or VMV Circuit Malfunction Possible Causes Setting Conditions * EVAP Purge valve VPWR circuit open * EVAP Purge control circuit open, shorted to ground or to power * EVAP canister purge valve is damaged EVAP * PCM has failed Engine started, engine running, and the PCM detected an unexpected voltage condition on the Purge or VMV solenoid circuit when the device was cycled "on" and "off" during the CCM test. This code sets in 2 Trip(s). It looks llike 9 times out of 10, our diagnostic support network shows that the PCM replacement has fixed it.
Where is the evaperator canister on a 2000 Chevy Blazer?
your evap canister is located underneath the vehicle beside the drivers left rear qauter panel beside your spare tire.s-10 blazers have alot of problem with these leaking.If you pull off any of the lines and gas or charcoal bits come out, the unit is bad, or if it wieghs over 4 pounds i think then it's bad.
Where is the evap purge valve located on a S-10 Chevrolet pickup 2wd?
Up on top the engine, passenger side assuming the engine is a 4.3 V-6. The year and engine info would help. You can also look for the small green plastic cap within the engine bay. The valve under the cap is a test port for the EVAP system. Follow the line to the engine from the test port. It will lead you to the EVAP purge valve.
Where does evap service port connect on Chevy s 10?
To the fuel tank
What is the purpose of the vacuum canister on an 89 s-10?
The canister stores gasoline vapors from the fuel tank so they can be ran into the engine and burned.
When was Ty Pickup born?
Ty Pickup was born on 1897-10-29.
When was Pickup Man created?
Pickup Man was created on 1994-10-17.
