0
Where is the exhaust back pressure sensor on a international 2005 dt466?
Wiki User
∙ 7y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you raise the speed limiter on a 2006 international 4300 dt466 without going to the dealer?
Disrupt the frequency of the signal from the speed sensor to the ECM.
Where is the crankshaft sensor located at on a 2003 internationl dt466?
On the engine.
Where MAP sensor located on a 2003 International 4300 truck?
It depends on what engine you have. I have the Dt466 engine in mine and my MAP sensor is located on top of the valve cover towards the front of the engine it has a three prong pigtail on it.
What is the oil capacity for a 2004 international 4300 dt466?
29 quarts
How much does a International DT466 engine weigh?
A little over 1400 lbs
What are the torque specs for an international dt466 main cap?
115 ft pounds
Repair manuel for a 1994 international dt466?
repair manuals for a 2001 international dt 466e model c195
What is international dt466?
DT466 is an inline six cylinder diesel motor manufactured by Navistar International. It's a 7.6 litre (466 cubic inch) motor, rated between 210 and 300 horsepower. It was superseded by the DT466E in 1994, which introduced electronic controls to the motor, although the badges on the side of International vehicles did not reflect this change, and still simply said "DT466". As of 2007, the DT466 was redesigned to meet the 2007 emissions regulations, and is now produced and marketed as the MaxxForce DT.
How many miles per gallon does 2001 international dt466 get?
I have the DT466 in a 24' van. Use it lightly loaded, normally about 8000 pounds tops, and we get 9 MPG.
What is the standard fuel pressure on DT466 engine fuel rail?
the fuel pressure should be 40-60 psi and should be checked under full load :)
Oil capacity for 2003 international dt466?
It takes 15 quarts of 15W40 diesel oil I highly recommend Rotella 15W40
Why is your 2001 DT466 diesel engine leaking excessive engine oil through exhaust manifold?
Excessive crank case blow by caused by worn piston rings
