On an inline six cylinder engine it is in the exhaust manifold directly under the carburetor. There is a flap that directs warm air to the carburetor so the gas can vaporize during warm up. Two external springs on either side of the stove control the operation of the flap. Proper operation of this flap is necessary to avoid stumbling, long warm up period, bad gas mileage and poor performance.
Check operation of exhaust "heat riser" valve. Also check exhaust header gasket for leaks. Heat riser should be near the exhaust header, in exhaust pipe connection.
A device called the heat riser has stuck or the heat riser hose has fallen off. could this loose part cause a metal raddling when you start to excelerate?
It's bound to be somewhere on the exhaust riser to the EGR valve. Look for about a 5/8 inch tube coming up from the rear exhaust manifold.
A heat riser is a duct that allows heat to rise up from the exhaust manifold. It's purpose is to warm the air being brought into the intake manifold preventing the freezing of moisture, that might otherwise cause the engine to stop running or run properly.
Riser
If it has the bi-metal spring actuated valve it has a donut. If it has a vacuum operated valve it has no donut.
A riser that has a curved shape at front.
LPX or mini LPX uses a riser card ( also called a bus riser or daughter card). LPX motherboard has the riser card near the center, whereas the NLX motherboard has the riser at the edge of the board.
Ronn Riser was born in 1962, in USA.
trade and riser are the terms used for stair case. trade is used for the breadth of and riser is used for height of stairs.
Neil Riser was born on 1962-04-25.
Paul Riser was born on 1936-08-15.