answersLogoWhite
Chrysler Town and Country

Where is the fan blower resistor of a 1996 Chrysler Town and Country that the AC blower operates at full speed only?

515253

Top Answer
User Avatar
Wiki User
2006-05-16 22:06:39
2006-05-16 22:06:39

in the engine compartment, it is on the passenger side fire wall, near the top. It is on the evaporator case.

1

Related Questions

User Avatar

The blower resistor is under the hood on the passenger side. It is below the wiper cowl, over the strut tower. It snaps into the firewall.

User Avatar

The blower resistor is behind the glove box. It mounts to the HVAC housing.

User Avatar

The blower motor resistor is over the passenger side strut tower, under the hood.

User Avatar

The blower resistor has failed.The blower resistor has failed.

User Avatar

The blower resistor is above the strut tower on the passenger side under the hood.

User Avatar

The blower motor resistor is mounted behind the glove box door.

User Avatar

The blower motor resistor has failed.The blower motor resistor has failed.

User Avatar

On an auto temp system the blower motor resistor has failed and needs replaced.

User Avatar

Its located on the firewall under the hood on the passengers side...

User Avatar

The blower resistor is under the hood, over the passenger side strut tower. You will need to look way up under the wiper cowl.

User Avatar

It is in the under hood fuse box, 40 amps. If your fan is inoperative, the problem is probably a failed blower resistor. The resistor is located behind the glove box.

User Avatar

When the fan is on high it does not run through the blower motor resistor. The low speeds don't work because the blower motor resistor is bad.

User Avatar

The most likely problem is the blower resistor located behind the glove box door.

User Avatar

If the fan runs with the HVAC panel shut off, the blower resistor power module has failed.

User Avatar

The blower motor resistor location on a Chrysler 300M is on the passenger side of the vehicle. It is on the floorboard next to the inside firewall, just in front of where the passenger sits.

User Avatar

Fig 15 Blower Motor ResistorNOTE: The blower motor resistor is located on the lower right side of the heater housing.REMOVAL# Remove lower right underpanel silencer/duct. # Disconnect wiring connectors on blower motor resistor. # Remove blower motor resistor retaining screws. # Pull blower motor resistor out of heater housing.

User Avatar

On the auto temp system that happens when the blower motor resistor fails. It is behind the glove box.

User Avatar

Blower motor resistors are usually located close to the blower motor.

User Avatar

The resistor is under the hood on the passenger side. It is installed under the wiper cowl, over the passenger side strut tower.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.