Hydraulic system oil is added through the filler cap under the seat. The oil level check plug is a 1/4 inch pipe plug located on the RH side of the axle housing a little ways above the floorboard about in line where your heel
would be if you were in the seat.
The Ford Jubilee has three areas for fluid. The transmission has a filler cap near the gear shift. The hydraulic fluid has a filler cap under the edge of the seat and the differential has a filler cap behind the seat. There is a small dipstick on the right hand side to determine hydraulic fluid level.
were do you put the hydraulic fluid in 2000 ford tractor
In a Ford Ranger , the hydraulic clutch uses ( DOT 3 BRAKE FLUID )
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger
Looking at the rear of the tractor you will see two bolts above the center link bar on the rear axle. These are the filler plugs for your hydraulic and rear axle. Look under the driver side of your seat, there is a dipstick to check the hydraulic, differential, and wet-brake fluid levels.
In a Ford 4610, you need to add the hydraulic fluid to the rear axle. The Ford 4610 is a 1989 tractor that retailed at close to $19,000.
it should be on the drivers side under the hood near the fire wall drive safe
You can see a diagram of a hydraulic pump for the Ford 3000 tractor on the website called YesterdaysTractors.com. Just click on the link for the Ford 3000 and choose the diagram that you wish to view. You can also find these diagrams on TractorByNet online.
under the seat were do you add the hydraulic fluid
50liters
in the oil filler tube
in the back axle