Chrysler LHS

Where is the flasher relay on a 1995 Chrysler LHS?

757677

Top Answer
User Avatar
Wiki User
2004-11-19 09:55:55
2004-11-19 09:55:55

Under the dash close to the steering column.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The fuel pump in a 1995 Chrysler LHS is in the fuel tank. There is an access panel under the carpet in the trunk.

User Avatar

Lower driver side of the engine.

User Avatar

in the fuse box That's not the relay fuse, the relay fuse is a big black with 4 or5 prong box located under the steering column. You must disable the airbag system 1st prior to removing this fuse.

User Avatar

Chrysler LHS was created in 1994.

User Avatar

There is no sensor. There is a turn signal flasher relay and hazard flasher relay. They are located somewhere under the dash. Where I could not say. You just have to look for them. Look in your owner's manual, and it may list the location. If not go to www.autozone.com and use the component location tool.

User Avatar

Are you sure you replaced the Turn Signal Flasher Relay? Some vehicles has a relay for the turn signals and one for the hazard lights. Possibly you changed the wrong one. It is also possible you purchased a new defective part. It happens although rarely.

User Avatar

Remove the wiring harness from the back of your 1995 Chrysler LHS alternator. Remove the alternator belt. Remove the alternator retaining bolts. The alternator will come off and can be replaced with the new alternator.

User Avatar

It is in the under hood fuse box. The lid is labeled.

User Avatar

It might be in the dash bored of the car.

User Avatar

There is on bolted to the left and right side of the engine.

User Avatar

It does not have a mass airflow sensor.

User Avatar

A Chrysler LHS does not have a reset switch.

User Avatar

you could try it or I think it would not fit but you could try it

User Avatar

Reset switch, no. Chrysler does not have those. Fuse for the relays, yes all relays are protected by fuses.

User Avatar

A Chrysler LHS does not have a mass airflow sensor.

User Avatar

A 2001 Chrysler LHS has suspension struts.

User Avatar

how do you install a crankshaft sensor on a 94 Chrysler lhs....where is it located on a 94 Chrysler lhs???????????????????loisanne0@hotmail.com

User Avatar

IT requires a special tool, a three jaw puller.

User Avatar

A Chrysler LHS does not have a fuel system reset.

User Avatar

A Chrysler LHS does not have an inertia or reset switch.

User Avatar

1996-1997 Dodge Intrepid, Chrysler Concorde, Chrysler LHS, Eagle Vision.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.