There is a switch on the end cap of the light switch stalk. Pull this cap straigt out after the lights are turned on only. There should be a small light that comes on in the upper right corner of the instrument panel. Turn the driving lights off by pushing in on the end cap that you pulled out. Also, if you turn the ignition off before turning off your lights, the headlights will remain on for about 30 seconds or so after the light switch is turned to the off position.
On a bracket, above the brake pedal.
It is on a bracket, just above the brake pedal.
A 2002 Chrysler Sebring was not built with a cabin filter.
Ignition switch 2002 Chrysler sebring. Original key will not turn? Is there a fuse or replace the switch?
A 2002 Chrysler Sebring convertible does not have a maf sensor.
No, in 2002 the Chrysler sedan was a Sebring.
The 2002 Chrysler Sebring six-cylinder engine oil pressure light alerts the automobile operator when the oil pressure is too low. The oil pressure light will illuminate red.
The high pressure AC switch on a 2002 Chrysler Sebring is located on the passenger side of the engine bay. It is paired with the low pressure hose and is mounted near the coolant and power steering reservoirs.
A 2002 Chrysler Sebring sedan does not have a MAF sensor.
fuse, bulbs or switch
A 2002 Chrysler Sebring has an overhead cam engine. That means it does not have push rods.
The 2.7L out of a Chrysler Sebring or Dodge Stratus.The 2.7L out of a Chrysler Sebring or Dodge Stratus.