Cars & Vehicles
Fuel Filters
Ford Bronco

Where is the fuel filter located and how do you replace it on a 1989 Ford Bronco XLT?

454647

Top Answer
User Avatar
Wiki User
2008-02-28 04:43:07
2008-02-28 04:43:07

If you crawl under the truck on the driver's side door, looking up at the frame. You'll see the fuel line coming from the tank to the external fuel pump mounted on the frame. Follow the fuel line out of the fuel pump about two feet, and you'll find the fuel filter behind the shield. When I change it I have the new filter in hand. Loosen up the hardware on the clamp holding the fuel filter "not the shield", then remove the clips on each side of the fuel lines PRIOR to removing the fuel lines. Remove the fuel line (on the filter) coming in from the fuel pump first then plug it into the new filter. Take off the last fuel line, and old filter, then slide in the new filter into the clamp, and plug in the fuel line. Make sure the fuel filter is installed correctly just like the old filter, and the fuel lines are fully seated, then put your new clips back on. Tighten up the hardware on the clamp, then check for leaks. Before removing anything from the fuel lines the pressure needs to be relieved. Do so by starting the engine and activating the inertia switch located on the interior firewall above the drivers feet. It's a black retangular plastic switch. I believe you lift up on the plunger. After the filter has been changed, reactivate switch by pressing red button down. On my 1989 the fuel filter is directly in front of the fuel pump, not 2 feet.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

On a full sized Bronco, it is located in front of the fuel pump between the frame rails near the drivers feet.

User Avatar

where is the fuel fiter located on a 1989 buick century wagon 2.5l 4cyl, and how do i go about replacing it.

User Avatar

It is located under the driver side headlight.

User Avatar

The thermostat is located in the water neck where the top radiator hose goes on. Its mounted in an O-ring, just pop it out with a screwdriver and replace it.

User Avatar

The PCM for the 89 Bronco is located on the firewall on the driver side. You can access it from inside the cab, behind the parking brake pedal.

User Avatar

the fuel filter is located on the firewall

User Avatar

Change fuel filter add a bottle of gas and injector treatments will

User Avatar

Hi The fuel filter is located on the left inner fender...pull filter out of spring clip to unhook the hoses. Put new filter on...make sure it's the right way for fuel injected engines.

User Avatar

its located where the tranny bolts up to the motor. disconnect the three wires from the starter, then take the three bolts out of the starter and pull it out. just remember where the wires go!!

User Avatar

The jack should be located under the hood, on the passenger side.

User Avatar

On the interior firewall to the left of the steering column

User Avatar

This vehicle does not have a cabin filter. There is nothing to replace.

User Avatar

list of fuses for 1989 bronco 2

User Avatar

drivers side just go under the car closer to the front tire and grab your wrenches and have at her

User Avatar

Usually located in frame rail on driver's side or right at front of fuel tank--follow fuel lines

User Avatar

The fuel filter is located under the hood on the back firewall, passenger side.

User Avatar

Follow the top radiator hose from the radiator , where it connects to the engine is where the engine thermostat is located

User Avatar

Drain coolant. Remove upper radiator hose. unbolt 3 bolts on thermostat housing. take out old one. reverse to install.

User Avatar

its located on the firewall in the middle at the top

User Avatar

Well you take out the tail light assem and remove the blown bulb

User Avatar

The fuel filter is on a front corner of the fuel tank.

User Avatar

it is under the car on the driver side just ahead of the rear wheel. easy to replace. ive got an 88

User Avatar

look on the driver side firewall by the brake pedal

User Avatar

The oil pump is bolted to the bottom of the engine , inside the oil pan


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.