It is on passengerside directly above the fender and will be white in color and two fuel lines going to it.It has a metal holder that keeps it secure and make sure you hook the lines up exactly as the original.Pay attention to the arrow for fuel flow on the top of the new filter which should be on the fitler normally.I would disconnect one line at a time and have several rags to catch the fuel that will leak out as u unhook it.If u connect the lines wrong the truck will not supply fuel to the carb to run.Ten minute job at most with clean up included.
i drive a 2000 Mazda Etude and does not have a fuel filter.
Sorry..there is no cabin filter for protege..mine is 2000 model.
Don't know what year model your pickup is but on 1994-2005 4-cylinder DOHC Mazda engines, the switch is screwed into an oil filter adapter located at the oil filter. Haynes Repair Manual 1994-2005 Mazda Pickups.
If there is no fuel filter on the fuel lines or near the engine or fuel tank then it has a permanent filter mounted inside the fuel tank that requires no maintenance.
according to a local dealer that model has no modulator valve on its automatic transmission sorry !
Well on my 1987 it is stamped on the driver side frame rail (with the left front wheel removed) you can see the serial numbers stamped into the metal at the curveature behind the shock going toward the fender weld.Should be the same for your model.Easy.
you don't the lash on a 90 model is not adjustable. the valves are hydrolic,unless they have been replaced with manual ones.
The Mazda Tribute has been production since model year 2007. The exact fuel filter will vary by year. The OEM fuel filter for the 2011 Mazda Tribute with the 3.0L V6 is Ford Motorcraft #FG872.
Yes, a Mazda B2000 is most definitely a 4-cylinder with a 2.0L engine. However, technically Mazda didn't produce the B2000 as a 1988 model. It was made in 1986-1987. Then in 1989 Mazda made the B2200 Pickup, which is a 2.2L 4 cylinder.
The fuel filter coming in side of the fuel tank on the fuel pump , but i thing no need to change because its hard job. I have 2003 model Mazda 6 alreday 196000 KM & i did not change the fuel filter. Regards Abdullah al brahim from K.S.A
On the 2007/2008 model, it's halfway up the back of the engine. You need to access it from underneath after removing the plastic cover.
Yes you can.The 86-93 model mazda b series trucks have the same bumper and mounting points while some designs are different in LOOKS like with chrome or trim on them.They are interchangeable.The end caps are the same except on the four wheel drive trucks(this is just specific to those).Ok simple swap is A OK!