Check in the front passenger footwell , under the front edge of the carpet ,
just to the right of the transmission hump . I believe that is where the fuel
pump inertia switch ( shut off switch ) is located in a 1991 Ford Explorer
It does not have a reset button or inertia switch.
GM vehicles do not have inertia/reset switches.
There is no ECU reset button.
doesnt have a reset, it only has a relay under the hood.
A 1991 Oldsmobile does not have a reset button.
A 1991 Chrysler does not have a reset switch.
Press reset button assembly located in trunk on driver side fender under carpeting
Push the reset button.
It is located in the lft rear of the vehicle in the jack compartment. It should be a little red button. If you are thinking this need to be reset because it is not starting listen for the fuel pump when turning the ignition on, if you hear it buzzing this is not the problem.
The fuel pump inertia switch is located in your right front passenger area. It is located on the right side of the transmission hump on the toe board, just under the edge of the carpet. If you don't see any gas leaking, or smell any gas, push the button down that has popped up on the top of the switch. This will allow power to go to your fuel pump.
Gm does not use reset/inertia switches
People will be able to help you out a lot better if they know what reset button you are looking for. Make sure you say model, year, and what engine is in the car. Will be looking for more specific question so we can help you out.
it is a small button underneath the dash on the passenger side of the car, it is down where the passengers ankle would be. behind the carpet
I believe it is in the right front passenger footwell , under the front edge of the carpet , mounted on the toe board , just to the right of the transmission hump
i don't know about a probe forsure but is in the trunk on a tompo or topaz on th left side near the top
the dealer should of reset it when they did the service. To reset the maintenance required button, insert your key into the slot next to the required maintenance button on the dash and push it in. It will reset the button to "green".
behind the steering wheel on the speedometer for the car
it is located on the firewall under the brake booster
I believe only Ford uses them.
I believe there is a button in the trunk. I will check my manual
It doesn't exist.
There is a reset button on the passenger side under the dash. Turn the ignigion on but don't start the car. Press and hold the reset button for about 5-15 seconds. Turn off ignigion and turn back on. It should reset then. If not, push the button with the ignition off and then turn the car on after the 15 seconds.
General Motors products do not use inertia/reset switches.
the fuel pump is located in the fuel tank