answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2009-02-15 13:51:40

This vehicle doesn't have a fuel reset button. If your fuel pump doesn't produce pressure, you may have a blown fuse (in the fuse box under the hood), a relay failure (same place) or a failing fuel pump. If your little SUV has more than 80k, and has been consistantly driven a great deal of TIME (not distance) with less than 1/4 tank of fule, suspect the pump failure. The pump is in the tank for a variety of reasons, the formost of which is that the fuel in the tank is used to cool the pump. If there is no MASS of fuel to absorb the heat, then the pump overheats, and will ultimately fail prematurely. If this is the case, the tank will have to come out, and if it is full, will be awkward to handle. Some pump modules are available at the parts stores, while others must come from the dealer, and can be as much as $500.00 for the parts alone. Labor compounds the expense of shop repair.

001
๐Ÿ™
2
๐Ÿคจ
5
๐Ÿ˜ฎ
2
๐Ÿ˜‚
2

Your Answer

Related Questions


Jeep vehicles do not use inertia/reset switches.



reset button for what? if you want to reset everything there isn't a button but you can dissconnect the negative battery cable and wait about ten minutes that should clear everything



Hit the step button until you see 0km to service the hold down the reset button.


http://www.wjjeeps.com/fuses.htm



Jeep does not use inertia/reset switches.Jeep does not use inertia/reset switches.



Press and hold the reset button about 3 seconds.it gonna be appear how many miles you need... it works..


Press the step button until "0 miles to service" is displayed. Press and hold "reset" until it resets.


Press the step button until zero miles to service is displayed. Press and hold reset.


you un plug the jeeps battery for a few minuets and then the computer resets.


A 1987 Jeep Cherokee does not have a reset button. The fuel system is computer controlled.


Press the step button on the overhead console until the miles to service shows. The hold down reset until it resets.


Press the step button until "0 miles to service" is displayed. Press and hold "reset" until it resets.


The Select button and the set button, hold them down together, should reset with in a couple of seconds.


A 2002 Jeep Grand Cherokee does not have a kill switch.


There is NO fuel reset button.What are you trying to do?Dean


you reset it by hitting step until you see "miles remaining to service" then you hold reset button and it will change to 3000


To reset the oil life in the display press and hold down the reset button for 3 to 5 seconds. This works for the GTP. Hope this helps. "G"


The 2004 Grand Cherokee Larado will have an overhead display for drivers information. The service engine soon message can be reset anytime desired by simply pressing and holding the reset button until the message changes to read the mileage interval programmed. The same process is used to reset the trip odometer and the MPG calculation.



Where is my whirlpool reset button located serial#her46114134


turn the ignition ON and set the display to compass/Temperature press the RESET button approximately five second the last variance zone number will display press the STEP button to select the new variance zone and press the RESET button to resume normal operation



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.