The fuel pump relay switch would be found under the hood, on the firewall, drivers side, near the power brake booster. The oil pressure sending unit would be found under the hood, in back of the engine, on top, very close to the distributor.
The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.
It is important for a car owner to know the location of all the car parts. The fuel tank pressure sensor for a 1998 GMC Sonoma is located in the fuel pump assembly.?æ
The crankshaft position sensor on a 97 GM Sonoma 2.2 engine is located on the lower right side of the engine. It is near the ignition control module.
The crankshaft sensor is located on the passenger side of the engine, close to the coil pack. It is easier to reach it from under a raised vehicle.
The sensor is down on the front of the oil pan just behind the crankshaft pully, which is located at the front of the engine.
The temperature sensor on a 1998 Sonoma is located in the engine compartment just to the left of the distributor. Look for a plastic part that looks like a bolt that is held on with a clip and a small wire harness. It is on the top of the manifold.
on the drivers side underneath the engine by the front tire. You will notice a pigtail leading to the exhaust in this area. This o2 sensor is the main sensor, there should be a catalytic o2 sensor located after the converter.
were is csp on gmc sonoma 2.2
where is the iat sensor located on a 2003 gmc sonoma truck
IT IS LOCATED ON THE FUEL PUMP ASSEMBLY. It is the smaller electrical connector on top of the fuel tank
it is located on the passenger side of the engine compartment by the overflow bottle
The camshaft sensor is located inside the distributor.