It is located on the end of the fuel rail. It is held on by two small bolts. It will have a small wire harness plugged into it, and a vacuum line plugged onto the bottom of it. It is only used on returnless type fuel systems of the Contour.
it is located where the transmission is and is very easy to change. on a 2000 ford contour that is.
go to autozone they will check it free
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
fuel pressure sensor is located on the tank
P0102 - Mass Airflow ( MAF ) sensor circuit low input
The weight of a Ford Contour will vary depending on the year and model of the Contour. A 2000 Ford Contour has a curb weight of 3,126 pounds.
Your 2000 Ford Contour cannot reverse because of a transmission failure problem.
In order to change a fuel pressure regulator in a 2000 Ford Contour, start by relieving the pressure from the fuel system. The regulator is part of the fuel pump module. Place the new regulator in position in the engine and tighten any bolts.?æ
The 2.0 L - DOHC - 4 cylinder engine in a 2000 Ford Contour has a timing belt
According to the 2000 Ford Contour owners manual ( 5W-30 ) You can view the 2000 Ford Contour owners manual online at : www . motorcraft service . com ( no spaces ) Click on Owner Guides
A 2000 Ford Contour ( in North America ) Has either a 2.0 litre four cylinder or a 2.5 litre V6 engine
Typically the pressure sensors are in the top of the fuel tank.