In the right front passenger footwell , in the corner by the kick panel , above the carpet
Lots of patience! Hold the reset button, then when it says"to reset hold reset button" let up briefly and hold it! Lots of patience! Hold the reset button, then when it says"to reset hold reset button" let up briefly and hold it!
i have a 2000 xls and the reset is above the speedometer
Unfortunately There is not a reset oil button ( Like the explorer) at least for the 2003 Expedition ( Eddie Bower model)
I believe the fuel pump inertia switch is in the front passenger footwell , under the front edge of the carpet , mounted on the toe board , just to the right of the transmission hump ( there is a reset button on the switch ) on a 1993 Ford Explorer
it's in the right front passenger footwell , under the front edge of the carpet , mounted on the toe board , to the right of the transmission hump
under passanger side dash at top of carpet.
could be a bad wire in your engine harness
In the front passenger footwell , by the kick panel
Be in the car, key in the "on" position, make sure all doors are closed. Press the setup button until you reach the oil life. Hold down the reset button and after a few seconds it will go to 100%. If you are not using full synthetic than you should bring it to 70% or so which should be about 4,000 mile expectancy, I believe if you click the reset button just after you reset it, it will decrease by 10% increments. I am doing this all from memory so I am sorry if this is wrong.
That should be in the right front passenger footwell , by the kick panel
In the right front passenger footwell , by the kick panel
In the right front passengers footwell , behind ( or by ) the kick panel