answersLogoWhite

0


Best Answer

It is listed in the 1991 Pontiac Firebird Operations Manual

User Avatar

Wiki User

โˆ™ 2009-05-08 21:18:37
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the fuse for the third brake light on a 1991 Pontiac Firebird?
Write your answer...
Submit
Related questions

Does 91 Pontiac firebird have 3rd gen?

A firebird can't "have" third gen. It either is or is not a third generation firebird, and Yes, a 1991 is a third generation.


How do you fix the rear tail lights on your 1988 Pontiac firebird not working?

First of all.Whats wrong with them. Second if its a turning signal or a brake light problem Third is it reverse lights Being more specific does help get more answers


How do you change the center third brake light on a 2003 E320?

Begin by removing the wiring harness from your third brake light. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.


Where is the fuse for the third brake light on a 2001 F-150?

the third brake light is direct from brake light switch no fuse


What is a 1988 Pontiac GTA 5.7L V8 tbi engine?

It is a Pontiac Firebird Third Generation produced from 1982 - 1992.


Third brake light on a 96 Chevy beretta?

how to change third or center brake light on Chevy beretta 95


How do you replace third brake light in 2009 Hyundai sonata?

How to change third brake light in 2009 Hyundai sonata


How do you replace the third brake light in a 2006 Avalon?

Begin by removing the wiring harness from the back of your 2006 Avalon. Remove the third brake light retaining screws. Reverse the process to install your new third brake light.


How do you replace the third brake light on a 2005 Buick lacrosse?

How do you replace the third rear brake light in a 2005 buick allure


Can you put a third generation firebird transmission into a second generation firebird?

Anything can be done with enough work. However after 1981, f bodies had chevy engines rather than the Pontiac. The Chevy trans will not bolt to the Pontiac block willingly.


How do you replace the third brake light on a 2001 Tahoe?

Remove the wiring harness from the third brake light. Remove the third brake light retaining screws. The entire unit will need to be replaced. The unit is sealed and the lightbulb cannot be replaced.


Who was the third rear brake light named for?

The third brake light is named for then Secretary of Transportation Elizabeth Dole and are called "dole lights".


What year did Chevelle introduce the third brake light?

Chevelles never had a third brake light since the Chevelle name was dropped after 1977. However, third brake lights were first installed (and required) in 1986.


What is a third brake light used for?

A third brake light is used to provide a deceleration warning to vehicles that can't see the left and right lights. You can learn more about these brake lights at the Wikipedia.


If a 1991 Nissan brake light inside the car comes on but turns off after 20 plus minutes do you need new brakes or brake light sensor?

The brake light, a red light shaped like a headlight on the dash means that one or more exterior lights are not working. It could be a taillight, brake light, side marker, license plate light, or third brake light. It stays on all the time if it's a side marker or any light besides the brake light. If it's the brake or third brake light it will come on only when you press the brake pedal.


How do you remove a third brake light?

with a hammer


Why do your brake lights work but the third brake light does not and not the ABS light is on?

New bulb needed or broken wire


Where is brake light switch on 92 Lumina Z34?

Above the brake pedal. If your main brake lights dont work but your third center brake light does, then the brake light switch is not the problem. Its is the turn signal switch.


Why is third brake light the only one working on a 2007 landrover lr3?

There are a few reasons that the third brake light is the only one working. One reason could be that there is a short in the wires of your main brake light. Another reason is that the light bulb has blown out.


Who invented the third rear brake?

In 1974, psychologist John Voevodsky invented the third brake light. It is also rumored that a New York cab driver, after getting rear ended 12 times, placed a third brake light on his cab in 1973.


When did cadillac introduce the third brake light?

1985


Where are the brake light fuses on a Nissan navara 2007?

You can find the 2007 Nissan brake light fuse in the fuse box. The brake light fuse will be in the second column, third from the top.


How do you remove light bulb for high mount brake light on a 1998 Pontiac Bonneville?

1998 Pontiac Bonneville center high mount stop (third 3rd brake light) bulb replacement: Purchase the correct replacement center high mount stop (third 3rd brake light) bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the center high mount stop (third 3rd brake light) bulb replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. If there are multiple bulbs, you may want to consider replacing all at the same time in order to keep brightness and color equal (optional).


Why would rear parkers work but not brake lights?

first check brake light fuse second check light bulbs,they should be double element third check the brake light switch located on the brake pedal


Center high brake light on 1991 Pontiac Trans-Am has stopped working bulb is ok switch on brake pedal checks out ok earth at lamp socket is good but no power is there relay in the system?

Look for a separate fuse to the third brakelight.