0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How can you tell when a fuse is blown out from an eagle vision?
Something won't work. One can test any fuse with a VOM (volt-ohm-meter) or DMM (digital multi-meter)
Where is the meter fuse located on a Ford Escort?
It is in the passenger compartment fuse block.
If the head lights on a 1987 Nissan 300 ZX stopped rolling up or down should you check the fuses?
Get a multi-meter and check for power at the motor that moves the lights up and down. If there is 12V, your motor is shot. If there isn't 12V then it could be a fuse. Use your multi-meter again to check for voltage across the fuse. If there is 12V across the fuse, the fuse is blown. If there is virtually no voltage measured across the fuse, the fuse is good. You might have other problems. Good luck.
How do you measure the resistance of a 30-amp cartridge fuse in ohms?
Set a Volt-Ohm meter to Ohms and put the two leads from meter across the fuse. One on each end where the metal is located. The meter should read zero ohms if the fuse is NOT blown.
How do you tell if my fuel-pump fuse is bad on my 98 subaru?
Fuse are clear plastic so it can be check visually. If the wire in the fuse isn't broken/burnt it is good. Better yet you can use a multi-meter or test light to check the fuse and for power without removing the fuse. If you have power on both sides of the fuse the fuse is good.
Where is the airmatic pump fuse on Mercedes s class 430 situated?
On the S-500 Mercedes, it located in the engine compartment passenger side fuse box. It's the first 40 amp (orange color large fuse) located next to the 60 amp fuse. Check with ohm meter for continunity. It may look like it's not blown. CHECK WITH METER!!!!!!
How do you measure amperage across fuse?
Technically, you don't measure amperage ACROSS a fuse, you measure current THROUGH a fuse, and the units of measure are amperage. If you want to measure the current though a fuse on a single device, say a TV, or computer, you can use a multi-meter. You will need to 'redirect' all the current so it goes through the multi-meter. ie: ----|fuse|---|device|--- would be rewired to be: ----|fuse|-----|black probe|---|multi-meter|---|red probe|-----|device|------ If you want to measure the current through a larger fuse, like the main fuse in your house, you'll need a current clamp. This is a clamp that you can put on ONE of the incoming power wires. It measures the magnetic field generated by the current. This is the much easier way since you don't have to do any re-wiring to redirect the current, but costs more money. ----|fuse|---@@---|device|--- [the @@ is the current clamp, note that it doesn't matter where the current clamp is placed, so long as it's only around ONE wire] Whatever you do, be careful, electricity is dangerous.
How do you find the fuse line in a house?
If you are looking for the main panel, look for where wires enter the house or where the electric meter is located.
How can you tell if your fan fuse is blown in your car?
Remove the fuse and check it with a ohm meter. If you have no ohm meter then just replace it with a new fuse.
How do you use multitester?
One of the easiest ways to check for faulty devices and parts, is to use a multi-tester, sometimes called a multi-meter. Testing continuity by using the ohm setting will tell you if the connection through the device is complete or if it has opened and is no longer usable. For instance, if you place one of the test leads on one side of a fuse and the other lead on the other side of the fuse, you should show a short circuit or 0 ohms. If your meter shows infinite resistance, the fuse is bad and should be replaced.
Why would the condenser fan fuse blow out every time you turn on the AC in an Acura Integra?
You have a short in the wiring or switch. Use either an ohm or multi meter to trace it out. Start at the switch and work back toward the fan fuse connection.
How do you remove the fuse for the fog lights on your 2001 PT Cruiser?
pull out your #8 fuse its a 15 amp fuse and is located inside the car in my case anyways that's the only way I can shut mine off now thanks to the faulty multi switch
