There is a multi-purpose fuse in the junction block. No. 10, rated capacity 10, housing red, controls door lock actuator and door lock power relay.
Try going to Kelleybluebook.com put in your info and they will tell you.
In a 1990 Eagle Talon TSi, the power windows are typically controlled by a fuse located in the fuse box under the dashboard. Specifically, it is usually the 30-amp fuse labeled "Power Window" or similar. Always refer to the vehicle's owner's manual for the exact fuse layout and specifications to ensure accuracy.
The power transistor on a 1995 Eagle Talon is typically located in the engine compartment, mounted on or near the ignition coil pack. It is often housed in a plastic cover or bracket. For specific identification, refer to the vehicle's service manual or wiring diagram, as the exact position may vary slightly based on the engine type and configuration.
check ur coil pack or your power transistor
on turbo 125 turbo 210-250
you hooked something up wrong
Try a new battery, or get a jump start. Sometimes there is not enough power in the battery to start the engine.
A power transistor in an Eagle Talon is an electronic component that regulates and amplifies electrical signals, playing a crucial role in controlling various systems within the vehicle, such as the ignition and fuel injection. It helps manage the flow of current and voltage, ensuring the efficient operation of the car's electronic systems. Proper functioning of the power transistor is essential for maintaining optimal vehicle performance and reliability.
Non-turbos run about 135HP, Turbos run about 195HP.
In a 2007 Ford Focus, the power locks are typically controlled by a fuse located in the interior fuse box. The specific fuse for the power locks is usually labeled as "Power Door Locks" and is often a 15-amp fuse. If the power locks are not functioning, checking and replacing this fuse may resolve the issue. Always consult the owner's manual for the exact fuse location and specifications.
The bcm that controls power windows, locks and doors is located on the driverside floor.
Take out the old one, and then put in the new one. You'll probably have to undo some bolts and stuff. Watch out for that slippery stuff.