Brake light switch needs adjusting or replacing. It is too sensitive.
the brake system needs bled. meaning the system has air in it and the air needs removed. through the bleeder valve
the switch on brake pedal is faulty and needs replacing
Simple your tail light bulbs have fused and needs replacing
Things you need to check is brake fluid oil, and brake pads. If they are fine then it is the brake switch which needs replacing. Also check the handbrakes as sometimes it is left engaged.
If no light is on and no relay is stuck then the battery has a dead cell and needs replacing.
If you're talking about the brake light staying on, it may be either the small plastic button that pushes on the brake light switch on the brake pedal, or the brake light switch itself. If you're talking about taillights only, it may possibly be the light switch on the steering column that has gone bad and needs replacing.
Defective or out of adjustment brake light switch, if the switch is mounted on the brake lever. If the switch is on the master cylinder, then it needs replacing.
It normally means that your brake switch needs replacing
It needs replacing
Remove brake light interior trim panels. Then you push and twist the socket for the brake light that needs replacing. Then pull out socket. then pull out bulb from socket and place new bulb in the light socket. Once bulb is installed into light socket. Place the socket where you removed it from brake light housing. Push and twist clockwise to lock back in place. Then replace trim panels.
It could be. If you fill it and it drains quickly, then yes it needs repair. But sometimes brake fluid just lowers over time and the fluid is all that needs replacing.
it needs brake fluid
When break lights do not turn off when the brake pedal is fully retracted suggests two possible causes: * The brake light switch is out of adjustment and needs to be adjusted. * The brake light switch is defective and needs to be replaced.
check your brake fluid and if that's ok your brake pads'Answer:If the light says "Brake Lamp", it means you have a tail light bulb that needs to be replaced.
Brake light switch is out of adjustment or needs relplaced.
the switch needs to be adjusted
Brake Booster needs replaceing
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
most likely? the caliper needs replacing.
Because the seat switch is faulty and needs replacing.
needs new alternator
Question: Does the turn signal blink on the right rear? I suspect not. Both the brake light and the turn signal use the same filament. If one is burnt out, the other will not work either. If so, the bulb needs replacing.
If a Honda Civic brake light is on then the system needs to be checked. The pads may be low and require maintenance to be safely operable.