Defective or out of adjustment brake light switch, if the switch is mounted on the brake lever. If the switch is on the master cylinder, then it needs replacing.
There is a faulty fuse that goes to the interior lights. There could also be a short in the wiring that leads to the lights.
If you live in the United States, your Intrepid will not have running lights. If your car is from Canada however, it will. Either way, the Daytime Running Light module is in the relay box under the hood, on the right hand side
Not sure how to while you're driving, but if your parked - press in on your e-brake, turn your car off, then turn it on and your lights won't be on. To turn them back on, simply release the brake.
where is the fuse for driving lights for a 2010 ford escape
check fuses
If the brake lights stay on when the car is not running on most vehicles, including the 1994 Dodge Intrepid, there is probably a short somewhere in the wiring to the brake lights. The first place to investigate this problem would be the wires along the firewall that control the brake lights. Also, check the brake light switch above the brake pedal.
It is doing a trial again and again and recoding the outcomes. For example tossing a coin and recording whether the coin came up heads or tails, or driving along a road to a specific set of traffic lights and recoding whether the lights were red or green (or amber)..
Drivers must use bright lights only when driving?
I have a 1996 Chevy Silverado that I want to turn the driving lights off. How do I do that? Thank you
low lights
Hazard Lights
The driving lights on a Volvo xc90 are turned off by turning the knob on the left side of the steering column. Driving lights are used to notify other driver's of the vehicle's presence.