Want this question answered?
No, use a fuse rated for the proper voltage.
assuming this is a 12 volt system....45 amps.
The 1952 Dodge truck line used a 6 volt electical system with a generator.
A fuse rated for 250 v is fine for 240 v. The fuse might be a cartridge fuse, so it must fit the available socket, or it might be fuse wire that has to be fitted in the holder correctly.
No, a 250-Amp fuse would be much larger than a 25-amp fuse. A fuse is generally designed to have a thermal runaway and melt the connection when there is too much current for too long.
No, use a fuse rated for the proper voltage.
20 amp on a 12 volt system
assuming this is a 12 volt system....45 amps.
Check for broken wires. You can check for this using a simple cheap volt/ohm meter.
No
Broken wire or wire connection at the switch and/or fuse. You can check for any voltage present at those locations with a simple volt/ohm meter.
The 1952 Dodge truck line used a 6 volt electical system with a generator.
Yes a 10 amp fuse can be used to protect a 240 volt circuit. The amperage rating of a fuse is based on the given amperage load of the circuit. The voltage rating on a fuse must match or be higher than the voltage that is applied to the fuse. In other words you can not use a 240 volt fuse on a 277, 347, 480 or 600 volt circuit but it can be used on a 120 volt, Manufactures of switching equipment today make it impossible to interchange different voltage fuses to be installed in higher voltage switches.
No. Is a 6 volt system.
Can I run 480 volt , 60 HZ motor at a 380 volt , 60 Hz system?
1967 was the first year for the 12 volt system in the VW's.
A fuse rated for 250 v is fine for 240 v. The fuse might be a cartridge fuse, so it must fit the available socket, or it might be fuse wire that has to be fitted in the holder correctly.