0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the fuse located for the windscreen washers on a citroen xsara Picasso?
The fuse for the windscreen washers on a Citoen Xsara Picasso is located in the engine. It is inside the compartment box.
Where is the brake fuse on a citroen xsara Picasso 2002?
in the fuse box
What is the fuse box layout of a xsara Picasso?
The Citroen Xsara Picasso is a compact car produced from 1999 to 2010. The fuse box layout of it is where all the fuses for the circuits are.
Where do you find the fuse for the cruise control on a 2004 citroen xsara Picasso?
There is not one.
Where is the fuse box in a Citroen Xsara Picasso located?
There are two places for fuses on the Citroen xsara Picasso the main ones are to the right of the steering wheel behind a little storage area just pull the recess out and the fuses are there the other is under the bonnet.
What is the fuse box layout of a Citroen Xsara Picasso?
The fuse box layout can be found on the inside cover of the fuse box. The fuse box layout diagram can be obtained from most auto-parts stores.
Where is position of windscreen washer fuse on citroen xsara Picasso?
In the engine compartment fuse box it is the Minature fuse 10A (red one) as you look at the fuse box it is the bottom left one can't remember the fuse number
Location for the Cigarette lighter fuse for a citroen Picasso car?
Citroen Xsara Picasso 2006 LX - F22 (20Amp Yellow) - fuses behind panel below steering wheel to the right.
Where do you replace the hazard light fuse in a ford explorer?
You replace the hazard light fuse in a Ford Explorer in the fuse panel box. The fuse panel box is located under the vehicle's hood.
Is there a fuse for the hazard warning light?
no fuse the switch is the common fault
How do you turn off your hazard lights that are stuck on?
Pull the hazard light fuse.
How do you change brake light switch on a Citroen Xsara Picasso?
Remove the fuse board cover at the right hand side of the steering wheel, the switch is located behind the mass of cables, a quarter turn to the left will allow the switch to be removed.
