2005 fiesta header tank fitting instructions
2005 fiesta header tank fitting instructions
how do I replace my 2005 fiesta expansion header tank
It is fitted to the bottom of the plastic header tank, and can be accessed by removing the tank.
This depends on whether the hot water comes from a combination boiler or from a hot water tank with a header tank feeding it. For a combination boiler the fault would probably be at the boiler, possibly from scale in the heat exchanger. For the system that uses the header tank and a hot water cylinder it could be that the float valve in the header tank is stuck an there for it is not refilling the tank or debris has entered the tank and is blocking the outlet.
Reason for question: Plumber left valve open and flooded house The hot water (heater) tank is fed from a 'header tank'; normally in the loft space but can be combined with the main heater tank (fortic). The header is filled from the water main. Unless the header is drained or its outlet is closed off, it will drain down through the open valve of the hot water (heater) tank.
where the header tank is for the radiator there is a lid that needs a flat screwdriver to take off. to the bottom right of the header tank. bit hard to explain that.. ha. but its there.
Cracked Engine Block or blown head gasket.
The coolant level is low or the level sensor in the heder tank is faulty (common).
If it has a bleeder then you bleed it.
check ignition leads next to rad. header tank for water
normally back to header tank but in some systems where there is no tank there will be a small pipe going through wall to the outside of the property
It refers to the level sensor in the header tank. Ie, your coolant level is low.