Want this question answered?
On a 1995 Ford Ranger : The heater blower motor is in the ENGINE COMPARTMENT , near the firewall , on the passenger side of the engine
The blower resistor assembly is located on the heater case to the right of the blower motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
is there air comming out but its not warm? if there is no air at all its the blower motor if there is air but its not warm it may freon but im not sure
Not sure about the relay, but there is a blower resistor assembly located on the heater case to the right of the blower motor.
There is a heater control valve on the 1999 Ford Ranger. There is no thermal vacuum valve on this year of the vehicle.
The Heater Core will be located behind the dash. Hope that Helps.
The blower resistor assembly is located on the heater case to the right of the bloser motor. - Haynes Repair Manual #36071, 1993-2005 Ford Ranger Pick-ups
The blower resistor assembly is located under the hood, on the heater case to the right of the blower motor. Haynes Manual #36071
Replace blower motor resistor usually located in the duct work or out in engine compartment in ductwork by heater motor.
There isn't one. There'll be a fuse for the HVAC blower, but the heater itself doesn't use electricity (other than the blower fan). That year Ranger should have cables going to the blend door, so there won't be electricity there.
The blower resistor assembly is located on the heater case to the right of the blower motor. The blower motor is located under the hood on the passenger side firewall.
You have a 1999 Ford Ranger 3.0.