If you cannot find a hole already there with a rubber plug then run the wire along with something else that is already running into the interior. If that is not possible then drill your own hole. Just make sure you are not drilling into something on the other side. Purchase a rubber grommet to fit the hole you will have to drill and run the wire through the grommet. Drill the hole so that the grommet fits tightly.
The battery charger can be used but it is not recommended. The battery charger does not have filtering on the its output like a power supply does. You will probably hear an AC ripple on the amplifier which will become very annoying when listening to the amplifier.
You need to pass it under the car just under the passenger floor mat you have a hole just the right size for the cable
It is probably the output amplifier chip.
there is no specific hole for this. use an existing rubber seal in firewall. take thin screw driver and insert in seal , stretching seal enough to push wire thru. seal will close around wire when you remove screwdriver
Straight to the battery through your firewall straight to the battery to the to the positive post
Question: Can a power amplifier amplify the power? An amplifier can amplify the voltage or the current. Power can be converted to heat.
A voltage amplifier does not have to supply significant current bur a power amplifier does.
maybe 30 mins
To power a very small internal amplifier inside the guitar. This is for the active cnotrols.
No. In an amplifier, Power Out > Power in. In a transformer Power Out ~= Power In (minus internal losses). An AC generator is more like an amplifier than a transformer.
Yes it will but it is made to work on car battery power.
most like you loseing your ground from your battery or the groung from your battery to your firewall or your poistive most likely your ground..