answersLogoWhite

0


Best Answer

The IAT sensor, or Intake Air Temperature sensor, is typically located in the air duct between the air filter and the throttle body.

User Avatar

Wiki User

15y ago
This answer is:
User Avatar
More answers
User Avatar

Wiki User

14y ago

Between air filter and throttle body on the piece that the air flows through.

This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is IAT Sensor on Ford AU 4.0L?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the IAT sensor in 2001 Au Ford Falcon?

The IAT sensor on an AU2 is known as a T-MAP sensor. It is a Manifold Air Pressure and Air Temp sensor in one. It is located Under the throttle body air intake side, where the rubber bend goes into the throttle body, look under this rubber pipe and you'll see a small black plastic box about 2x2cm with a cable into it at the bottom. (on AU2). Wiring is pin1/blu-yell = MAP;pin2/or-blk= 5V supply from ecu;pin3/blk-yell= air temp;pin4/blk-white= 0V /gnd.


When was Ford AU Falcon created?

Ford AU Falcon was created in 1998.


Can you put a AU Ford Falcon diff in a BA Ford Falcon?

Only the AU IRS version.


Where is it possible to get a Ford AU?

There is no such thing as a Ford AU. If one is interested in finding Ford cars in Australia, websites such as Ford Australia or CarSales could be of interest.


What size speakers does an Au falcon have?

ford falcon au's take 5x7 speakers front and back


How do you rewind the ks on a Ford Falcon au?

ILLEGALY


What does flashing s on Ford Falcon au dash mean?

If there is a flashing S on your Ford Falcon AU on the dashboard that is a warning. The S on this model means that your vehicle needs to be serviced.


How do you flush cooling system on a Ford Falcon AU?

It's a design fault overlooked by ford


What is the code for the 2000 au Ford Falcon stereo?

each car has its own code,, contact ford.


Where is the crank position sensor on a ford AU II?

Above the bottom pulley (Harmonic Balancer) connected to the front cover (Timing cover) with 2X8mm bolts and the plug is about 150mm to the passenger side near the aircon pump. The other round one with just 1 bolt is the cam position sensor.


What are the torque settings for an au 6-cylinder falcon with vct?

pressure plate torque settings for ford falcon au 6 cylinder


What kind of cars are listed on the Ford AU website?

One the Ford AU website, the following cars are listed: Fiesta, Focus, Mondeo, Falcon and G series MKII, Territory, All New Ford Kuga, Falcon UTE MKII, Ranger, Transit.