0
What else can I help you with?
What is the cost to replace an ignition module in a 93 Chevy Lumina?
All together depending on where you go parts and labor about 722.00 : - )
1993 Chevy lumina euro 3.1 will not start no spark no power going to the ignition module from computer what is the problem?
Check your fuses
Where is the ignition control module located on a 1991 Chevy Lumina AVP 3.1?
If you have disributorless ignition it will be mounted under the coil pack . If you vehicle still has a distributor it will be in the dist.
Where is the ignition module located in a 1993 Chevy Lumina?
In a 1993 Chevy Lumina, the ignition module is typically located on the ignition coil pack, which is mounted on the engine. It is usually found near the front of the engine, close to the intake manifold. To access it, you may need to remove the engine cover or other components obstructing the view. Be sure to disconnect the battery before attempting any repairs.
How do you remove the ignition switch on your 98' Chevy lumina ltz car?
You will need to remove the retaining ring at the top of your 1998 Chevy Lumina ignition switch. Slide the ignition switch out. Remove the wiring harness.
Where is the ignition control module 1997 Chevy cavalier 2.2 L?
where is the ignition control module loacted on a 1997 chevy cavalier
Where is the ignition module on a 1986 Chevy Celebrity?
On the V6 the ignition module is under the distributor cap.
Diagram for ignition switch 95 lumina?
I need a Diagram for a 1995 Chevy Lumina iginition switch??
What causes no spark on 1993 Chevy Lumina?
A BAD CRANK SENSOR WILL CAUSE NO SPARK AND NO PULSE SIGNAL TO FUEL INJECTORS a bad ignition module will cause no spark its located under the ignition coil trio pack
How do you change the ignition control module in a 1988 Chevy Silverado 5.7 L?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Where is the ignition module on a 1999 4 cylinder Chevy S 10?
The 1999 Chevy S 10 pickup truck ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
How do you bypass the ignition module to crank a 2000 Chevy blazer 4.3?
It will not run if you bypass the ignition module (no spark).
