It is located just left and back from the air intake as your looking from the front of the engine. It has a wire that runs to the Distributor cap. It has two electrical sensors on it as well.
It will not run if you bypass the ignition module (no spark).
It is attached to the fan.
on the evaporator / dryer
Bottom of the motor, passenger side.
it on the fire wall
Yes. I own a 2000 Chevy Blazer.
How do you set the timing on a 2000 Chevy blazer (V6)
where is the fuel pump inertia switch located on a 2000 blazer
Inside the bottom of the engine block.
in the fuel tank
An alternator from a 2000 Chevy blazer will fit a 2002 S10 blazer with a little fabrication.
you have to take the transmissionpan off and it is located at the end closest to the engine.