Under hood, driver side, front side of strut tower, mounted on fenderwell For a 5.0L engine
The Ignition control module is located under the coil which is on top of the driver side wheel well, Commonly known as an ignitor.
The ignition module is mounted to the side of the distributor. It a rectangular piece.
The ignition module is located in the distributor under the rotor, it plugs in.
The ignition module is located in the distributor under the rotor, it plugs in.
== answer== Could be a bad ignition control module or coil,points if equiped,cap,or rotor,bad ignition switch.
its inside the distributor
Attached to the ignition coil you will find an "igniter". Per the local Toyota Dealer parts dept. there is no ignition module. The igniter takes it's place. I have been trying to locate the module on my 1980 corona as well and that was the answer they gave me. Try this eBay link and you will see a picture of the igniter: http://cgi.eBay.com/83-88-TOYOTA-COROLLA-TERCEL-NOVA-IGNITER-89620-16080_W0QQitemZ130140198470QQihZ003QQcategoryZ33691QQrdZ1QQssPageNameZWD1VQQcmdZViewItem?_trksid=p1638.m118
It does not have one. Crankshaft position sensors are used in distributorless ignition systems to tell the ignition control module where the crankshaft is in its rotation. The 1982 thru 1986 2.8L engines had distributors so they had no need of a crankshaft position sensor.
There is no ignition module in a '84 laser. They have a coil and distributor unless it has been modified. If you don't get a spark across the points in the distributor when you try to start the engine you probably need a new coil.
Inside the distributor, under the rotor.
It is set and adjusted by the engine control module.
i have a 1984 bronco 2 and the ignition control mod went bad on it. It turned over but had no spark. The part was about 40 dollars and is located on the distributor. It takes a special tool to take it off. I changed mine and it started first try.