answersLogoWhite
Starters and Ignition Systems
Ford Explorer Eddie Bauer
Ford Escort LX

Where is the ignition control module on a 95 Ford Escort LX 1.9?

567

Top Answer
User Avatar
Wiki User
Answered 2007-11-13 04:41:11

not certain however you can find this in a haynes or a chilltons repair guide, if you're planning to do alot of repairs it's the best source of info you can find.

good luck;)

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Your Answer

Related Questions


The ignition module is mounted to the side of the distributor. It a rectangular piece.


You can find the Ford Focus ignition control module beneath the drivers side dashboard. The ignition control module will be above the accelerator pedal.


The 1994 Ford Aerostar ignition control module is located on the firewall in the engine compartment. The ignition control module will be on the drivers side of the firewall.



If by control module you are referring to an ignition module then you need to remove it from the distributor and take it in to a shop for testing ,it requires special equipment for testing.A new module runs from $50-$100 depending on model


how do you remove the ignition control module on a 1988 ford f-250 pickup?


It's called the EEC (Electronic Engine Control Module) or the PCM (Powertrain Control Module) It is located under the instrument panel on the floor tunnel ahead of the floor console. It has a ton of wires going into it.


Not sure on a zx2. On an Escort LX it is behind the fuse box in the engine compartment.


Please check your spark plugs,wires,distributor and rotor or the ignition coil module. My '93 LX has an ignition coil module.


1994 was the last year the Ranger used an ignition control module on the 2.3 and 2.5. The ignition control module was attached to the lower intake manifold.


There is not a stand-alone ignition control module in the Windstars.Ignition control is fully handled by the Powertrain Control Moduel (PCM).See "Related Questions" below for more


The ignition control module for a 1995 ford f150 is an important part of the drive train. If the module is failing then the engine will run erratically or not start at all.


I am pretty sure that it is on the right side of the battery behind the fuse box in both the 1.8 and 1.9L models


The Ignition control module is mounted under the hood. It is on the fire wall right beside the hood strut,


If you're looking for a stand-alone ignition controlmodule, there isn't one on the Windstar.This job has been transferred to the Powertrain Control Module (PCM) and its direct control of the coilpack.


Most likely it is the Ignition Control Module.



ignition module is found behind battery box right hand side


Yes ( according to motorcraft.com ) Motorcraft ( DY 959 ) Ignition Control Module for 1995 Ford Ranger 2.3 L - SOHC


From 1991 to 1995 with the EEC-IV system there is an external ignition control module mounted on the radiator support in front of the battery. Remove the battery in order to change the module. 1996 and newer with the EEC-V system, the ignition control module is incorperated into the powertrain control module (PCM) that is visible from the engine compartment, in the firewall, on the passenger side.


The 1993 Ford Taurus ignition module is located behind the dashboard. The ignition module, can be found on the drivers side of the dashboard.


I would check the ignition module located immediately to the right of your valve cover. A friend of mine has a Chevy Corsica that had the ignition control module or coil go bad and his car ran terrible. Ford stopped using distributors in Ford Escorts and their other 4 cylinder cars, because the TFI module on the distributor were notorious for going bad.




if there is a DIS module (side of the air intake, pass side) then there is no distributor DIS = distributorless ignition system



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.