I have the same year and make of pickup. the problem is in 1988 depending on how early or how late in the year it was produced it could have 2 different ignition systems. if its a late model like mine it wont have an ignition module. late models ran a hall effects pick up in the distributor. which just relays a signal to the computer and tells it when to ground the coil to send spark to the distributor. but on the early models it should be on the fire wall or the drivers side fender well. good luck hope this helps you
where is the ignition module located on a 1988 Mazda b2200
The engine computer, ignition module, is behind the battery in the left front fender.
module locatedwhere is the module on a 9 Chevy blazer
Inside the distributor cap under the rotor.
Behind the battery.Behind the battery.
how do you remove the ignition control module on a 1988 ford f-250 pickup?
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Under Dash Passenger side to the right of the kick panel
The ignition module on a 1988 Chevy Celebrity with 2.5 engine is on the side of the block beneath the intake manifold. You can simply follow the spark plug wires to it. As information the crankshaft position sensor is behind the ignition module.
The ignition amplifier module or power stage is bolted to the left front inner fender near the battery.
I'm working on a 1987 Festiva, and I *believe* that this is located inside the distributor housing.
check ehow.com cars-repairs
I am trying to find the 1988 chevy beretta computer module and where is it located?
Use a 5.5mm socket
Follow the 2 pin connector from the top of the coil located on the driver side front of the distributor. It should lead to a 2 pin connector, as well as a 4 pin connector. This is the ignition control module.
4.5 mm but has to be deepwell
Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,
It's on the left side of the battery, standing vertically it is an thin aluminum box with one harness coming out of it and it should say "control module" on it with a small green sticker. You'll find it!
Where is a starter realy located on a dodge ram van
In a 1988 Chevy pickup the ECM is located behind the glovebox.
Its located in the gas tank.
yes the 2.5L 4 cyl engine has the ignition module mounted to the back of the engine block,firewall side.the crank sensor is also there under the moduel and coils
change the pickup coil in distr
Yes it does, from the year 1988 through early 1999 models.
A 1998 Dakota does not have a ballast resistor.