there might two one is under the dash and the other is on the distruber(sp)
The engine computer, next to the battery, is the ignition module.
On the bottom side of the engine( front of the car) just below the exhause manifold. It is easiest to remove the mounting plate from the body of the engine, as balancing the coils on the module as you remove and insert screws if a real pain in the but. If anyone has any suggestions on waterproofing this area, I would greatly appreciate it, as I have gone through three of these modules in three years due to water getting into it and shorting the module out. This last time it was a coolant leak around a seal on the top of the water pump, spraying right into the module that caused it. Argh!
The only way I can explain it is to follow the wiring from your coil pack (where the spark plugs are) and the wires plug into the ignition module. Also go go www.wrenchead.ca and it has a manual that explains all. if you don't know the answer to a question please keep your moth shut ,please don't waste my time
The ignition module on a 86 ciara 2.5 is located under hood, center,lower engine area,below driver side of intake manifold . mounted inside of distributor
http://www.therangerstation.com/tech_library/TFI_Diagnostic.html Heat
The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
On the back of the distributor which is located on the top of the engine rear center, the ignition module (or TFI module as ford calls it) has two screws bolting it to the distributor and one electrical connection, when you replace this you MUST use di-electric grease when installing the new one or it will fail due to excessive heat created by the engine.
The engine computer (behind the battery) is the ignition module.
were is ignition drive module located in the engine
The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The ignition module is located in the distributor
The 1992 Chevrolet Corsica ignition module can be found on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
you don't have a 5.3L in the bronco. If it is indeed an Eddie Bauer then it should be a 5.8L, but other options include 5.0L and 4.9L.
The engine computer is the ignition module. It is the large black box under the hood.The engine computer is the ignition module. It is the large black box under the hood.
where is the ignition module located on a 1988 Mazda b2200
Assuming this has the 3.8 V-6 engine, the three coils are plugged into the ignition module.
The 1992 Dodge Ram 250 ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.