Starters and Ignition Systems
Mercury Sable
Ford Expedition XLT

Where is the ignition module located on a 1995 Mercury Sable and how do you replace it?

121314

Top Answer
User Avatar
Wiki User
2010-07-01 19:38:27
2010-07-01 19:38:27

Look at the distributer. There will be a module on the side that is either grey or black, and is about 3 inches long and 1 inch wide. It is held onto the distributer with two 7/32(5.5 mm) screws back inside of two holes on the module. You will have to get a thin wall socket to access them. I use a 1/4 drive deep well Sears Craftsman socket to get them off. NOTE: 7/32nds inch and 5.5MM are the same size, so either will work.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

ignition control module is located under the distributor cap

User Avatar

where is the ignition control module located on mercury marquis

User Avatar

The ignition module and coil are contained inside the distributor and are not serviced as separate parts.

User Avatar

where is the ignition module located on a 1988 Mazda b2200

User Avatar

Where is ignition control module on a 2001 mercury sable

User Avatar

DO NOT USE EXTERNAL MODULE,COMPUTER DRIVES SIGNAL FOR SPARK & TIMING

User Avatar

where is the ignition module located ina 2000 integra acura

User Avatar

The ignition module is located between the starter and the spark plugs on most vehicles.

User Avatar

The ignition module is located in the distributor under the rotor, it plugs in.

User Avatar

The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

User Avatar

The ignition control module sit directly below the distributor.

User Avatar

The ignition module is integral to the distributor and is not serviced as as separate part.

User Avatar

1983 doesnt have a crankshaft position sensor. you have an ignition module located on the side of the distributor.

User Avatar

The 1993 Ford Taurus ignition module is located behind the dashboard. The ignition module, can be found on the drivers side of the dashboard.

User Avatar

the ignition module is located in the distributor

User Avatar

where is the ignition control module on a 1995 Pontiac Transport and how do i replace it

User Avatar

The 1989 Ford Ranger pickup truck ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

User Avatar

The ignition module is located in the distributor under the rotor, it plugs in.

User Avatar

The 1996 Mitsubishi Eclipse ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.

User Avatar

module locatedwhere is the module on a 9 Chevy blazer

User Avatar

were is ignition drive module located in the engine

User Avatar

The engine computer (behind the battery) is the ignition module.

User Avatar

Assuming it is getting fuel and you have no spark, replace the ignition module.

User Avatar

there is no ignition control module on the 1996 model its all through the PCM


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.