I can't tell you exactly, but generally the IAT sensor is located on or near the air filter box. On some newer cars it's actually incorperated into the mass air flow sensor.
Compressor Inlet Temperature sensorfor a Gas turbine engine.
The Ford Escorts temperature sensor is mounted in the following locations. In the 1.8L engines it is located in the cylinder head, 1.9L engines it is threaded in the heater hose inlet pipe, and in 2.0L engines, it is located at the rear of the engine.
The 2003 Mondeo does not have a IAT Sensor is has a Temperature and Manifold Absolute Pressure Sensor (TMAP) The TMAP sensor fits directly into the inlet manifold and accurately measures the vacuum from the engine. The TMAP sensor consists of a temperature sensor and a pressure transducer and therefore replaces the IAT and the MAP sensors. The TMAP sensor provides the powertrain control module with information relating to inlet manifold vacuum and barometric pressure along with the temperature of the air in the inlet manifold. With the ignition on but without the engine running the sensor reads barometric pressure and when the engine is running, the sensor reads inlet manifold vacuum.
If you are talking about the Engine coolant temperature sensor (ECT) it is mounted in the following locations: 1.8L eng. in the cylinder head. 1.9L eng. threaded into the heater hose inlet pipe. and the 2.0L eng. at the left rear of the engine
The air intake temperature sender is located at the right hand side, back of the engine when looking from the front of the car. It is found screwed into the inlet manifold at the top of the engine. Disconnect wiring and unscrew sensor.
the temp sensor is on the drivers side, back of the engine near the inlet manifold, hope this helps a little, took me hours to find it :)
It is important to know the location of all the parts in a car. The inlet air temperature sensor on this vehicle is in the intake manifold.Ê
The automatic transmission oil temperature sensor on a 1992 Toyota Land Cruiser is in the engine compartment. it is near the inlet/outlet tubes.
Sensor is a push fit into the flexible pipe between the air filter box and the engine inlet.Just unclip the wiring connector and pull it out.
Inlet air temperature sensor circuit high. Check to see that the sensor is plugged in on the hose between the air box and engine.
Most engines have the temperature sensor either at the top water inlet or on the side of the block. Remove the sensor wiring, then unscrew the sensor to replace it.
Depending on the year, the sensor is most commonly on top of the engine beside of the top radiator hose inlet. Remove the wiring connector and the sensor can be screwed out using a socket.