It's inside the air cleaner housing.
On my '91 it's below the thermostat.
For the 1993 Toyota Tercel, the O2 sensor has three different wire colors. These colors are: black, blue, and white.
The temperature sending unit on a 1995 Toyota Tercel is typically located near the engine block, specifically on the cylinder head. It is usually positioned near the thermostat housing or close to the intake manifold. To access it, you may need to remove some components, such as the air intake, for better visibility and reach.
before cat
In a 1996 Toyota Tercel, the knock sensor is typically located on the engine block, near the intake manifold. It is usually positioned towards the rear of the engine, mounted on the cylinder head or engine block itself. To access it, you may need to remove some components, such as the intake manifold or other obstructing parts. Always refer to a service manual for specific details related to your vehicle.
its on the downpipe its 2 nuts you have to unscrew
the starter should be under the intake on the back of the motor.
Follow the intake air plenum from the air filter. It connects to the carburetor. The carburetor is mounted on the intake manifold.
Well, honey, the coolant temperature sensor on a 1995 Toyota Tercel is usually located near the thermostat housing or on the cylinder head. To replace it, first, make sure the engine is cool, then disconnect the electrical connector, unscrew the sensor using a wrench, apply some thread sealant on the new sensor, and install it in the same location. Don't forget to reconnect the electrical connector and refill the coolant if needed. Good luck, darling!
Yes, it is the small senor about the size of a car alarm remote with a four pin connector and a single vaccum hose connected to it. It is located on the firewall just to the right of the intake.
Toyota Tercel was created in 1978.
is a 91 Toyota tercel e85 compatiable