on the right hand side of the cylinder head!
right hand side of the motor!
about 250 bucks. if your mechanic gets a used one.
YES
This model probably has the Regina engine. The ignition coil should be mounted on the drivers side fender well close to the firewall.
The intake manifold on a 1990 Acura Integra connects to the head of the engine. Loosen all of the nuts from the manifold to the head, disconnect the throttle body, vacuum lines, fuel injectors and coolant lines then pull the manifold from the head.
There was no 1990 Chrysler Cirrus. Look on the intake manifold or hoses for the intake temp sensor.
On a 240 Volvo (which basically should have the same engine) it is directly under the intake manifold. On a 1985-740 previous comment is right On a 1990-740, driver side, on top the engine between injectors #3 and #4 a big tubing and a small vaccum hose attach to the flame trap
it is located on the drivers side of the engine under the air intake manifold
On a 1990 Jeep Wrangler, the IAT sensor is located on the intake manifold. It is a gray, two-wire system situated on the front of the manifold.
7 or 8
You want to look on the intake manifold on the Jeep Wrangler.
Behind the intake manifold on the firewall side.
Yes.