answersLogoWhite

0

You want to look on the intake manifold on the Jeep Wrangler.

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

Where is the MAP sensor on a 1998 Jeep Wrangler located?

It is located on the drivers side of the throttle body


Where is the maf sensor on a 2000 Jeep Wrangler?

It does not have a MAF, it uses a MAP sensor on the firewall above the intake.It does not have a MAF, it uses a MAP sensor on the firewall above the intake.


Do any one have a pic of a map sensor for a 1990 jeep Cherokee?

Below


Where is the MAP sensor Located On your 1997 jeep wrangler 6?

T is right beside your throttle body(onthe right if your standing in front of your jeep)


Where is the MAF sensor on a 1997 Jeep Wrangler Sport?

It's called a MAP sensor. But it by the air intake. It a black box on the the driver side of the air intake.


What does diagnostic code P 0108 mean for a 2004 jeep Wrangler 4 cylinder?

P0108 is map sensor volts too high. The map sensor could be bad, or the wiring could be broken. The map sensor bolts to the rear of the intake on the 4cyl.


What is a map sensor on a 1990 cutlas and were is it?

if it has a 3.3 there is no map sensor


Where is the MAP sensor located on the 2008 Jeep Wrangler?

The MAP (Manifold Absolute Pressure) sensor on a 2008 Jeep Wrangler is typically located on the intake manifold, near the throttle body. It is mounted directly on the manifold or attached to the intake duct. To access it, you'll need to remove any engine covers or components blocking your view, as it can be somewhat tucked away. Make sure to disconnect the electrical connector before attempting to remove or replace the sensor.


Where ia the map sensor located on a 1995 jeep wrangler?

On the firewall, in the center right above the valve cover. It has a vacuum line connected to it and a 3 pin weatherpack connector.


1990 Jeep Cherokee Sport that has no spark from the coil and I replaced both module and coil and still doesn't work What could be wrong?

Check the MAP sensor. To see if this is the problem, assuming that the Jeep won't start but is turning over, unplug the MAP sensor and then plug it back in. If you can start it now, the MAP sensor needs to be replaced. The MAP sensor is located in the engine compartment, where the firewall meets the body at the top of the engine compartment, on the driver's side. Good luck.


Does a 1990 Dynasty have a MAP Sensor?

Yes.


Where is the MAP sensor on a 1990 Mazda B2200?

The map sensor is on the air intake line to the throttle body....