The keyless entry receiver is under the console - behind the screens it's the temp and compass
Above your rearview mirror there should be a small black 'ball' (extending from the roof of the car). That is your module. If it's not there, I'm not sure if your Jeep has it. You can always refer to the owner's manual (you can snag one from eBay cheap if you don't already have it) or drop by your Jeep dealership to have them find out for you. Hope this helps!
A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.
Have to go into body computer with DRB3 to disable horn honk when locking vehicle.
1985-1996 Jeep Cherokee XJ should interchange 1997-2001 Jeep Cherokee XJ should interchange
An AW4 transmission from a 1991 Jeep Cherokee will not fit into a 1988 Jeep Cherokee. The transmissions in the varying years do not appear to be compatible with one another.
it has to be done by the dealer. =(
YOU CAN FINE ALMOST ANY KEYLESS ENTRY ON EBAY AND FOR A GOOD PRICE.. GOOD LUCK.........
I had the same problem. Google "keyless entry remote 2003 Jeep Grand Cherokee".
centre top dashboard (red dome)
You have to program it with a DRB (Scan tool).
dealer has to do it with factory scan tool
The keyless entry system must be programmed with an OBD II tool which the dealer or locksmith has. Sorry that this is not the answer your looking for, I didn't want to hear it either.
this is located in passenger door switch
Check instructions in the users manual.
Above your rearview mirror there should be a small black 'ball' (extending from the roof of the car). That is your module. If it's not there, I'm not sure if your Jeep has it. You can always refer to the owner's manual (you can snag one from eBay cheap if you don't already have it) or drop by your Jeep dealership to have them find out for you. Hope this helps!
Inside Passenger door connected to the window/door switches. has small antenna comming out of it.
This is all I have on keyless entrys.I hope it helps. Sit inside the vehicle with all the doors closed. Place ignition in the OFF position. Open the driver's door. Leave Open. Move the mechanical door lever to the LOCK position. Turn the ignition to the RUN position. Aim the transmitter at the Keyless Entry receiver and press Lock button. Hold for five seconds until the door locks cycle. Turn ignition OFF within 20 seconds.