Want this question answered?
where is the 2003 Cadillac Deville Crankshaft Position Sensors located
The knock sesor is located, on your Isuzu 1290, at the front of the engine. The sensor screws into the engine. Wires connect the sensor to the senor light.
The knock sensor is located under the manifold on the rear of the engine near the fire wall. You will need to get a new manifold gasket as this will have to be replaced after the knock sensor is reached.
How do you replace the speed senor on a 2001 cadillac catera
where is the oxygen senor located on 1995 jeep wrangler
i heard the speed sensor is connected to the rear right wheel.
iF YOU SLIDE IN UNDER THE TRUCK BEHIND THE PASSENGER FRONT WHEEL AND LOOK UP AT THE BOTTOM SIDE OF THE ENGINE, YOU WILL SEE THE STARTER. NOW JUST IN FRONT OF THE STARTER A FEW INCHES YOU WILL SEE THE KNOCK SENOR SCREEWED INTO THE SIDE OF THE ENGINE BLOCK. iT CAN BE HARD TO SEE.
it is on the drivers side of engine block screwed into block near side freeze plugs it is a 2 inch round sensor with a wire on top center of sensor
Should be located on the rear end of the transmission
if you think your grand am has a distributor, you might think about closing your hood and getting someone else to fix it
On the 1.9L engine it is above the starter. (Firewall side of the engine.)
in the rear