it is on the drivers side of engine block screwed into block near side freeze plugs it is a 2 inch round sensor with a wire on top center of sensor
The knock sesor is located, on your Isuzu 1290, at the front of the engine. The sensor screws into the engine. Wires connect the sensor to the senor light.
The knock sensor is located under the manifold on the rear of the engine near the fire wall. You will need to get a new manifold gasket as this will have to be replaced after the knock sensor is reached.
where is crankshaft position senor on chevy 3500 8.1 engine
It is built into the mass air flow sensor. 1 unit.
Passenger side of engine next to throttle body. It is the senor with the vacuum line running to it.
Looking For the answer myself
where is the oxygen senor located on 1995 jeep wrangler
That would be the distributor.
It is located near the air filter inline with the air flow to the motor. Unplug the two plugs one is the mass air flow senor the other is the air intake temp senor. Loose the clamps on the air intake hose both ends and remove hose. The mass air flow senor is a grid looking deveice, you should be looking at it on the air filter end of the hose.
iF YOU SLIDE IN UNDER THE TRUCK BEHIND THE PASSENGER FRONT WHEEL AND LOOK UP AT THE BOTTOM SIDE OF THE ENGINE, YOU WILL SEE THE STARTER. NOW JUST IN FRONT OF THE STARTER A FEW INCHES YOU WILL SEE THE KNOCK SENOR SCREEWED INTO THE SIDE OF THE ENGINE BLOCK. iT CAN BE HARD TO SEE.
air conditioner for1994 Chevy Beretta not working is there a senor that could be bad. system is charged.
Should be located on the rear end of the transmission