its located under the head on the drivers side you can buy the wire separate 25 bucks the head has to be removed
where is the nock sensor on my 95 toyota 4runner
it located under the transmission
engine bay
Knock sensor is located in the wall of the engine block facing the firewall. You have lift the car if you want to reach it.
under the intake manifold
The manufacturer states throttle body and the intake manifold must be removed to access the knock sensor. The knock sensor is located on side of cylinder block.
The Knock sesor is located on the backside of the block right underneath intake manifold.
It should be in the side of the engine facing the firewall.
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
It is in the trough below the EGR and intake manifold alongside the water bypass tube. Be careful with it if you take it out as they appear to be expensive.
where is the knock sensor on a 95 Toyota t100 v6
Its located deep inside the motor, between the heads. You have to dismantle the the whole top of the motor to get to it. I just had a blown head gasket repaired, and the mechanic showed me the knock sensor and said that while the heads were off and the engine was stripped down, and he could actually get to it, that I should replace the wires leading to the sensor.