answersLogoWhite

0


Best Answer

engine bay

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the knock sensor located on a Toyota 22re?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the knock sensor located Toyota pickup 22re?

Passenger side of the block, around the oil filter. http://www.pirate4x4.com/forum/showthread.php?t=618845


What can cause a 52 knock sensor codeon a 22re Toyota?

LoL, sorry it is the knock sensor itself. Yota tech has more on the subject. The knock sensor is located SW of the oil filter and just a little to the right of the fuel filter. You probably have a bad connection so you may want to pull the wire clean it and the connector and you should be all set. Make sure to check along the wire too to make sure it hasn't torn anywhere.


How do you change the throttle position sensor on a 1990 Toyota 22re engine?

take it to the crusher


Does anyone know part number for pigtail wire from knock sensor to main harness on 91 Toyota pickup 22re?

Connector 90980-11166 Wire that connects to connector then splices into wire that continues to ecu- 82998-12440 This is for my 93 22re 4x4 M/T Should be the same for your 91 22re good luck


Where is the speed sensor located on a 1994 22re engine?

The vehicle speed sensor (vss) is generally located at the rear of the transmission.


88 22RE coolant temperature sensor where is it?

should be located on the top of the thermostat housing.


What is the spark plug gap 1986 Toyota 22re?

The recommended spark plug gap for a 1986 Toyota 22RE is .032"


How do you bypass 1994 Toyota 4Runner SR5 knock sensor?

It is definitely not a good idea to bypass the sensor. If you have the 22re engine, then replacing the sensor or the wiring is trivial. Not so on the 3vze. The sensor is located under the upper and lower intake. So, for a quick bypass you can buy a new sensor and attach it to one of the engine mounts (there should be one on the drivers side, a couple of inches from the wiring harness). You can either drill through the mount, or bolt the sensor inside the loop of the hook. Note, this is a very temporary "fix". In this location, the sensor will not be able to perform its job. Be warned!


What is the spark plug gap for a 1994 Toyota 22RE engine?

The recommended spark plug gap for a 1994 Toyota 22RE is .032"


What are the wires coming out of a 22re ignitor?

what does the ignitor assembly do on a 87 toyota 4runner(22re)


What is the horsepower of 1994 Toyota 22re?

116


Where is the fuel pump located on a 1986 Toyota Pickup 2wd long bed with a 22re engine?

Inside the gas tank