Car Computers and Sensors
Mazda 626

Where is the lever position sensor on your Mazda 626 1998?

123

Top Answer
User Avatar
Wiki User
Answered
2008-09-20 17:32:49
2008-09-20 17:32:49

On the 2000 626 it is directly under the air filter box.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


where is the throttle position sensor on a 1998 Toyota 4runner???? can any one help???


The throttle position sensor is located on the throttle plate.


To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ



The wiring for the oxygen sensor PLUG is what I forgot to submit.


Where is can position sensor located on 1998chevy 3.1engine


Throttle position sensor. With the AC turned on, it causes a greater load on the engine, and a slightly decreased idle speed. The throttle position sensor would detect this immediately and raise your idle to where it would normally be if the AC wasn't running.


"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?


The cam position sensor is inside the distributor. The crankshaft position sensor mounts through the top driver side of the bell housing.


The egr position sensor is made into the egr valve. Look for the egr valve and you will find a plug with wires plugged into the egr valve. These wires are for the position sensor and they go back to the ecm ( engine control monitor)< computer> James= 15 year Mazda tech just a tip= with engine COLD,reach under valve and press on plunger and see if it moves freely(not easy) but freely. Hope this helps.


The crankshaft position sensor on a 1998 3.0 dodge caravan is located on the top of the bellhousing towards the firewall.


The camshaft position sensor is located beneath the wheel on a 1998 Ford Taurus 6 cylander Dohc.






I have a 1998 Metro with the 1.3l and the Camshaft Position Sensor is located on the bottom of the oil pan.


Throttle Position Sensor-is a sensor used to monitor the position of the throttle in an internal combustion engine. The sensor is usually located on the butterfly spindle so that it can directly monitor the position of the throttle valve butterfly.


Under the hood on the firewall passenger side it will say hitachi boost sensor on the top of it


The 1998 Saturn SL2 will show a code 340 and 341 for a camshaft position sensor because this part is also considered the crankshaft position sensor on the Saturn. The location of the crankshaft position sensor is behind the alternator on a 1998 Saturn SL2. Both crankshaft and camshaft are the same thing This vehicle is not equipped with a camshaft position sensor. Saturn is the only manufacture that uses a auto pulse generated inside the ignition control module in conjunction with the pulse received from the crankshaft position sensor to determine ignition and injection timing. If you have a code for camshaft position sensor the issue is with the pulse generator in the ignition control module.


Throttle Position Sensor(TPS)/Accelerator Pedal Position Sensor(APPS) signal voltage high.


The crankshaft position sensor is on the top driver side of the transmission bell housing.


The throttle position sensor is on the throttle shaft, on the throttle body.





Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.