The 1995 Mercury Villager turn signal relay switch is located beneath the drivers side dashboard. The turn signal relay switch will be left of the brake pedal.
The 2001 Kia signal flasher relay switch can be found beneath the drivers side dashboard. The signal flasher relay switch will be above the brake pedal.
You mean, I think, ignition switch module, which is the location of the ignition switch.
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
The switch must be shot. What kind of vehicle is it?
Possibly a neutral lockout switch, possibly a bad connection, possibly an ignition switch.
You probably have shorted wires inside the combo switch. The assembly will need to be replaced.
The switch just pops out of the dashboard.
It's part of the range switch on the transmission.
If you mean the starter solenoid, it's on the starter.
On the brake pedal.
Usually on the dash to the right of the steering wheel.
On the brake pedal assembly.
If you mean the reset button on top of the FUEL PUMP SHUT OFF SWITCH the switch is located in the drivers footwell , behind the kick panel , by your left foot ( there is an access hole ) on a 2000 Mercury Villager
There is only the speed sensor and the range switch.
behind the drivers side kick panel
It is in the drivers side kick panel.
No, there is no direct connection.