The thermostat on 4 cylinder, 2.3L Buick Skylark is on the bottom of the water pump. Remove the metal water line connected to the bottom of the water pump to find it. Remember the new O-ring with the new thermostat.
How do you replace the water pump and where is it located on a 1996 Buick Skylark V6
You can bypass your 1988 Buick Skylark heater core by removing the heater core water supply hoses. There will be to water hoses. Connect the water hoses to each other.
To change the water pump on a 1995 Buick Skylark with a four-cylinder engine, begin by disconnecting the negative battery cable and draining the coolant from the radiator. Remove the serpentine belt, then detach the water pump by unscrewing the bolts that hold it in place. Clean the mounting surface, apply gasket maker if needed, and install the new pump, ensuring it is securely fastened. Finally, reassemble everything, refill the coolant, and check for leaks.
From hoses attached to the wipers.
you have to take the timing chain off
That is an indication that head gasket is leaking. yes!
on the back of the engine down bottom. gm Jim
Between the water pump and firewall on passenger side
If it's the 3.1L motor, it's just below and to the right of the power steering pump. If it's a 2.4L QUAD4, it's on the backside of motor just underneath the exhaust manifold, very dumb location.
No, it's the same engine so it should fit.
It could be the radiator, the hoses, a leaking coolant tank or the water pump.